RrcD2D¶

compound module RrcD2D

D2D-capable variant of the Rrc layer. It adds the D2D mode controller (which coordinates RLC TX-queue draining across a mode switch) and, on the eNB/gNB side (hasD2DModeSelection==true), the periodic D2D mode selection module. Selected via ‘rrc.typename’ by the D2D-capable NICs.

Usage diagram¶

Inheritance diagram¶

Extends¶

Name	Type	Description
Rrc	compound module	RRC (Radio Resource Control) layer for LTE/NR networks.

Parameters¶

Name	Type	Default value
interfaceTableModule	string
routingTableModule	string
hasConnectionControl	bool	false
hasNrConnectionControl	bool	false
hasD2DModeSelection	bool	false

Properties¶

Name	Value	Description
display	i=block/control

Unassigned submodule parameters¶

Name	Type	Default value	Description
registration.interfaceTableModule	string
registration.interfaceName	string	“cellular”
registration.routingTableModule	string
registration.binderModule	string	“binder”
registration.connectionControlModule	string	“^.connectionControl”	The node’s control-plane entry point (see Rrc), told about a multicast group join
registration.sessionType	string	“”	UE only: the type of the UE’s session (see LteUe): a UE created during the run gets an IPv4 default route through the NIC only on an IP session, and the NIC of an Ethernet session is an Ethernet port; set by the NIC
bearerManagement.binderModule	string	“binder”	To reach a peer’s BearerManagement on RLF
bearerManagement.connectionControlModule	string	“^.connectionControl”	The node’s control-plane entry point (see Rrc), which a torn-down bearer’s DRB identity goes back through
bearerManagement.t311	double	0s	RRC re-establishment cell-selection timer (0 => release-to-IDLE)
bearerManagement.t301	double	0.1s	RRC re-establishment (request -> complete) timer
bearerManagement.headerCompressedSize	int	-1B	Removed, an error if set: header compression is configured per bearer (the rohc field of BearerConfigurator’s bearer definitions)
bearerManagement.pdcpEntityModuleType	string	“simu5g.stack.pdcp.LtePdcpEntity”	PDCP entity types: the full PDCP entity is a compound (PdcpEntityBase, TX+RX sides plus the leg split/join stage of a multi-leg bearer); the instantiable types are its subclasses (LtePdcpEntity, NrPdcpEntity). At a DC secondary a bearer’s PDCP lives at the master, so the secondary installs an PdcpRelayEntity (tunnels PDUs to/from the master) in its place.
bearerManagement.pdcpRelayEntityModuleType	string	“simu5g.stack.pdcp.PdcpRelayEntity”
bearerManagement.dualConnectivityEnabled	bool	false	Set by the NIC; two-leg (split-capable) bearers
bearerManagement.rlcTmEntityModuleType	string	“simu5g.stack.rlc.RlcTmEntity”	RLC entity types (compound modules): lteRlc* = LTE-FI bearers (TS 36.322), nrRlc* = NR bearers (SI/SO wire format, TS 38.322)
bearerManagement.lteRlcUmEntityModuleType	string	“simu5g.stack.rlc.LteRlcUmEntity”
bearerManagement.lteRlcAmEntityModuleType	string	“simu5g.stack.rlc.LteRlcAmEntity”
bearerManagement.nrRlcUmEntityModuleType	string	“simu5g.stack.rlc.NrRlcUmEntity”
bearerManagement.nrRlcAmEntityModuleType	string	“simu5g.stack.rlc.NrRlcAmEntity”
bearerManagement.registrationModule	string	“^.registration”	Module references for accessing other stack layers
bearerManagement.drbTableModule	string	“^.drbTable”
bearerManagement.ip2nicModule	string	“^.^.ip2nic”
bearerManagement.handoverPacketHolderModule	string	“^.^.handoverPacketHolder”	Attachment-ledger push target (UE only)
bearerManagement.pdcpMuxModule	string	“^.^.pdcpMux”
bearerManagement.pdcpDcMuxModule	string	“^.^.pdcpDcMux”
bearerManagement.d2dModeControllerModule	string	“^.d2dModeController”
bearerManagement.rlcMuxModule	string	“^.^.rlcMux”
bearerManagement.nrRlcMuxModule	string	“^.^.nrRlcMux”
bearerManagement.macModule	string	“^.^.mac”
bearerManagement.nrMacModule	string	“^.^.nrMac”
bearerManagement.sdapModule	string	“^.^.sdap”	Configuration push target; unresolvable (no SDAP on the NIC) = no pushes
bearerManagement.qosFlowClassifierModule	string	“^.^.qosFlowClassifier”	Uplink QFI rule push target; unresolvable (not a UE stack with SDAP) = no pushes
connectionControl.binderModule	string	“binder”
connectionControl.bearerConfiguratorModule	string	“bearerConfigurator”
connectionControl.coreControlModule	string	“coreControl”
connectionControl.bearerManagementModule	string	“^.bearerManagement”
connectionControl.macModule	string	“^.^.mac”
connectionControl.handoverPacketHolderModule	string	“^.^.handoverPacketHolder”
connectionControl.gtpUserModule	string	“^.^.^.relay.gtpUser”
connectionControl.gtpUserX2Module	string	“^.^.^.gtpUserX2”
connectionControl.macNodeId	int		The base station’s node id; the NIC sets it from the node’s
connectionControl.gateway	string	“”	The node’s core network gateway, as its gateway parameter names it; ignored at a node not connected to a core network (a secondary node)
nrConnectionControl.dynamicCellAssociation	bool	false
nrConnectionControl.enableHandover	bool	false	Allows handovers in the UE
nrConnectionControl.isNr	bool		Whether this instance is associated with the NR or the LTE stack
nrConnectionControl.macNodeId	int		MacNodeId of the stack leg this controller belongs to (set by the NIC)
nrConnectionControl.sessionType	string		The type of the session the UE requests at connection setup (see LteUe), set by the NIC
nrConnectionControl.handoverLatency	double	50ms	Handover duration
nrConnectionControl.handoverDetachmentTime	double	handoverLatency > 0s ? handoverLatency/2 : 25ms
nrConnectionControl.handoverAttachmentTime	double	handoverLatency > 0s ? handoverLatency-handoverDetachmentTime : handoverDetachmentTime
nrConnectionControl.minRssiDefault	bool	true	Whether minRssi is taken from PhyPisaData instead of the minRssi parameter
nrConnectionControl.minRssi	double	-99.0dB	Configurable minimum threshold RSSI for attaching to an eNB (meaningful only if minRssiDefault==false)
nrConnectionControl.hysteresisFactor	double	10
nrConnectionControl.binderModule	string	“binder”
nrConnectionControl.macModule	string	“^.^.mac”
nrConnectionControl.bearerManagementModule	string	“^.bearerManagement”
nrConnectionControl.handoverPacketHolderModule	string	“^.^.handoverPacketHolder”
nrConnectionControl.feedbackGeneratorModule	string	“^.^.dlFbGen”	TODO or “^.^.nrDlFbGen”
nrConnectionControl.otherConnectionControlModule	string	“”
nrConnectionControl.hasCollector	bool	false	True when node has a collector module (ueCollector/nrUeCollector) for this PHY module
d2dModeSelection.modeSelectionPeriod	double	1s
d2dModeSelection.binderModule	string	“binder”
d2dModeSelection.d2dBinderModule	string	“d2dBinder”	The network’s D2dBinder, which holds the D2D state
d2dModeSelection.macModule	string	“^.^.mac”
d2dModeSelection.connectionControlModule	string	“^.connectionControl”	The node’s control-plane entry point, which knows the UEs handing over

Source code¶

//
// D2D-capable variant of the ~Rrc layer. It adds the D2D mode controller
// (which coordinates RLC TX-queue draining across a mode switch) and, on the
// eNB/gNB side (hasD2DModeSelection==true), the periodic D2D mode selection
// module. Selected via 'rrc.typename' by the D2D-capable NICs.
//
module RrcD2D extends Rrc
{
    parameters:
        bool hasD2DModeSelection = default(false);

    submodules:
        d2dModeController: <default("D2DModeController")> like ID2DModeController {
            @display("p=850,80");
        }
        d2dModeSelection: <default("D2dModeSelectionBase")> like ID2DModeSelection if hasD2DModeSelection {
            @display("p=850,160");
        }
}

File: src/simu5g/stack/d2d/rrc/RrcD2D.ned